• Measure your work boot in inches or your shoe worn with TREDS from toe to heel.
  • Look at the boot sizing chart to determine the best possible size for you:
 
 
Boot SizeFits Men’s shoe:Heel-Toe Toe Length* (in inches)
X-SMALL4-5.5Between 10.125 to 10.625
SMALL6-7Between 10.625 to 11.125
MEDIUM7.5-8.5Between 11.125 to 11.75
Medium/Large(M/L)9-10Between 11.75 to 12.25
Large10.5-11.5Between 12.25 to 12.875
Large/X-Large(L/XL)12-13Between 12.875 to 13.5
X-LARGE14-16Between 13.5 to 14.25
XX-LARGE17+14.25+
*Based on leather work boot size, not TREDS boot. This is based on a more snug fit. If you prefer TREDS loose, please consider adding 1/4 inch to the heel to toe length measurement of your work boot to find the correct TREDS size.
 

We recommend wearing your TREDS over your work boots or shoes. To easily remove, cover your shoes with the plastic bag that comes with the boots and then pull on the overboots. You can also apply powder inside the boot before slipping it on.

TREDS rubber overboots are made with 100% natural latex rubber. Unlike imported synthetic PVC varieties, our rubber can stretch up to 800 percent and forms a strong resistance to tears and punctures. If your boot does get a small snag or puncture, it won’t continue to run and can be patched up easily with TREDS rubber patch or super glue.

Our one-piece, unlined molded rubber overboots is lightweight and boasts an easy on/off snap closure. What’s more, there is no left/right selection.

We manufacture TREDS based on normal leather work boot sizes.

For women: subtract two sizes to your current shoes to get the right TREDS size.

TREDS overboots are incredibly versatile and can be worn for:

  • Concrete pouring and finishing
  • Farming
  • Water treatment
  • Hunting
  • Landscaping
  • Gardening

TREDS are easy to care for. Simply spray off and dry regularly and keep them stored in a garage, out of extreme temperatures and direct sunlight when not in use. If you do get a puncture or hole in your boots, patch it up with a TREDS patch kit, super glue, or a standard tire patch.

TREDS are designed to be resistant to specific chemicals. Please contact our customer service team for more information at customerservice@treds.com.

Totally repairable, read below for instructions. If you have additional questions, please email
customerservice@treds.com.

Instructions
For hole or puncture , recommend patching TREDS Overboots with super glue, specifically gel
type. Clean and dry thoroughly the affected area. Apply gel super glue on hole, and allow 24
hours to set.

For small tear , use a tire patch or TREDS tear patch. Clean and dry thoroughly the affected
area. Apply super glue gel to patch on the inside of TREDS Overboots. Let set for 24 hours
prior to use.

We welcome new TREDS distributors! For information on opportunities to resell TREDS Overboots or any of our other products, please email sales@treds.com or visit our contact us page.

In your email, please include: Store/company name, contact name, contact phone, and the
product line interest. A sales representative will contact within 24 hours.